Clothing article tilt and fall

The reason:

1. The lapped dancing is serious, affect tension unstable;

2. Lapped radian is too long or too short; Lateral pressure knife and roller not vertical or the distance is too large;

Article 3. The edge of the medial and drum not vertical;

4. The back roller, impact tension instability.

The solution:

Article 1. The tilt is not serious, he shall not produce down, can be in the original lateral pressure appropriate position plus side pressure in front of the knife, the needle cloth righting;

Tilt 2. Serious or article has poured a circle, shall immediately stop, in the leather piece, before and after the lateral pressure knife in the clothing the centralizer, use hand lapped, until, after returning to normal and open motor lapped;

Article 3. Pour the laps more, can be in leather piece did not fall clothing, pour have clothing quit or cut off, again lapped joint;

4. Lapped beating, usually due to wire up cant file of edge uneven, not straight, abnormal, unwinding tension, such as bad, slow device failure according to the condition maintenance solution;

Article 5. Such as edge verticality, medial part of article should trim the edge of the part.

Needle cloth is little, the surface is rugged

The reason:

Lapped in stop, open more, affect the tension change;

2. Needle fabric tray put too close together, make clothing before entering into little guide wheel;

3. The base of the welding wire, wire hardness uneven;

4. The roller surface is bright and clean and lateral pressure on fly knife, sundry embedded needle cloth base;

5. Uneven rotation volume of packing, materials plate, eccentric;

6. Lapped radian is too small, import, Angle is too small.

7. Before the tension wheel groove with sundry;

8. Tension clamp piece of wear and tear.

Solution:

1. According to these reasons, belongs to the sense of operation, should be correct in the lapped, belongs to the sense of lapped process, should timely adjust the process;

2. Have been lapped to tip on a cylinder is little, high individual tooth, but at the end of the lapped with little flat inserted into the slot and is worth in the base of clothing repair lightly.

Appears to be a massive needlepoint is little clothing

The reason:

1. Tension splint wear grooving cause;

2. The straightening roller wear grooving.

Solution:

1. Before the package to check all the tension of the plywood, straightening roller, if significant wear and tear, should be a transfer;

2. In the process of the lapped shall regularly check, in order to timely find processing;

3. After lapped if found little, hook, not serious brush can increase the light time. Local serious when can take local dig; Should seriously affects the quality of the heavy bag.

Mobius winding wire

The reason:

1. Lapped Angle is not enough;

2. Lapped radian is too small;

The solution:

1. The lapped Angle adjustment to 2-3. ;

2. Adjust the lapped radian, to the lapped process requirement.