flat clothing

SXJT series

SXJT - 46 an average of 460 full arc tooth density satin Medium fine fine

SXJT - 42 teeth close an average of 420 a whole arc satin In the fine yarn

SXJT - 30 teeth close an average of 300 arc satin arrangement In the coarse yarn

Design features:

Lateral tip of encryption, between 0.30 0.40, vertical arrangement for the whole arc, there is no uniform isometric arrangement. Needlepoint density by dilute encryption, step by step from the start, fully embodies the carding intensity strengthened gradually, at the entrance to the longitudinal very loose, longitudinal very close at the exit. In the carding process, as well as reduce fiber damage, and achieve strong carding effect. Reducing neps, favorable to improve sliver quality. (the appended drawings)

All the arrangement of the gradient has encryption step by step from the start, in the general plant needle machine it is quite difficult to do.

SXPT series

SXPT part 520-52 dense area density gradient satin Medium fine fine

SXPT 520-52 - a close area density gradient satin Medium fine fine

SXPT part 410-41 dense area density gradient twill low comb, rotor spinning

SXPT part 370-37 dense area density gradient satin In the coarse yarn

SXPT - 38 dense area density gradient twill 380 parts

Design features:

(1) SXPT - 52, SXPT to 37, longitudinal two-thirds is gradually encryption, a third is longitudinal isometric evenly arranged, make the fiber in the thin area into the dense area out of the carding surface gradually wider and more reduce fiber damage. The design of its dilute region than graves is more rare.

(2) SXPT - 52 a, longitudinal 1/3 is gradually encryption, two-thirds are longitudinal isometric array. And close to graves, its role as above, the carding to fiber gradually.

SXPT - 41 (3), in 38 of twill arcuate alignment, the lateral tip from between 0.5 1.06, mainly is suitable for the impurity large low a cotton and add ShouMian, such as thin cotton fiber, the fiber in carding, effective longitudinal channels through the cover board. Use half arc arrangement, longitudinal tip from the part of the gradient, the formation of thin area and area, a third of the loose zone for arc, two-thirds of the dense area for alignment. Fibers in carding, gradually increase the carding, reducing neps, combed adequately.

SXST series

SXST - 45 450 satin horizontal dense arrangement Medium fine fine

SXST - 36 360 satin horizontal dense arrangement In the fine yarn

SXST - 27 270 satin horizontal dense arrangement Coarse yarn, cotton type chemical fiber

Design features:

(1) SXST - 45, SXST - 36, its lateral tip is not greater than 0.5 mm, 0.35 mm, 0.36 mm, than graves (0.4 mm). Transverse encryption, can make the fiber in the carding hit single fiber as soon as possible to improve the quality of combed cotton and production. And the base of the cylinder clothing is matching to the trend of the development of the thin. Vertical stitch is amplified in the design, can form a complete set of in cylinder high-speed carding, indigo is easy to eliminate the tiny impurities in fiber.

SXST - 27 (2) the satin, lateral tip distance from 0.35 to 0.40 enlarge to 0.49 mm, mainly in the spinning of coarse count cotton, cotton type chemical fiber, fiber through some channel amplifier, reduce the stress of the steel needle. By the optimal spinning range, which form a complete set of the base of the cylinder clothing thickness between 0.65 0.80 mm, such as the horizontal distance is too small, the needle is easy to cause too much stress and deformation of plate. Use 26/30 wire, improve the flexural performance of steel.